Buried scraper conveyorBuried scraper conveyor is a transport equipment which makes the bulk material transpo...
Pneumatic disc valveThe pneumatic plunger valve is mainly composed of frame, gate, screw, nut and other pa...
Single bag dust collectorAfter the dust gas of single-machine cloth bag filter enters into the single-machine, ...
YJD-A star unloaderYJD-A star unloader not only can withstand high temperature....
Three general formula distributorThree-way material distribution valve is mainly composed of body, valve shaft, valve p...The bucket elevator has low driving power and adopts the hopper intensive arrangement of inflow feeding, induction discharging and large capacity.Wide range of lifting, this kind of hoist on the type of materials, characteristics of less requirements, not only can lift the general powder, small granular materials, but also can lift grinding material, good sealing, less environmental pollution;Good operation reliability, advanced design principle and processing method, ensure the reliability of the whole machine operation, fault free time more than 20,000 hours.High lifting height. The lifting machine runs smoothly, so it can reach a high lifting height.Long service life, the elevator feed adopts the inflow type, no need to use the bucket to dig material, the phenomenon of extrusion and collision between materials is rare.TD bucket elevator is designed to ensure that the material in feeding, unloading, less scattered, reduce mechanical wear.
The bucket elevator is maintained and managed by designated personnel, and the key of the power switch box is managed by designated personnel.Bucket elevator is suitable for lifting from the low place to the high place. After the material is put into the hopper by vibration table, the machine automatically and continuously moves upward.The transmission speed can be adjusted according to the amount of transmission, and the height can be selected as needed.
1. Before lifting and landing, ring the warning bell before starting.
2. the elevator is not allowed to carry people up, down.
3. after the work, the hoist lifting tray should be on the ground, then cut off the power, close the upper and lower fence door.
4. often maintain the surrounding environment of the elevator health.
5. bucket elevator has hoist limiter and travel limiter, limiter should make the pulley in the lift to the distance of 300mm before the drum or pulley can automatically stop.
6. Bucket elevator shall have load mark, and the weight shall not be overloaded during lifting and landing (1T).
7. After power transmission, check the hoist limiter, travel limiter, interlock switch and other devices, with sensitive and reliable action, and conduct lifting test.
