After using the three-pass distributor for a period of time, we need to clean it. If we don't clean it in time, it will definitely cause the failure.When the electro-hydraulic three-way distributor is in operation, it may produce a lot of dust, which will get to the inside of the equipment and hinder the operation.In order to make the blow can be cleaned, the following small series will tell you some clear way.It is necessary to remove the screws, and clean the interior after removing them. When cleaning, attention should be paid to the wiring situation, and a cloth should be gently used to wipe it, so as to avoid short-circuit problems.After cleaning, lubricating oil needs to be added to ensure the flexibility of the machine.Sprinkler manufacturers said that in addition to the need to clean the internal work, the external plot is very important, after cleaning can let the heat quickly, avoid the temperature too high fault.Wipe with a dry cloth after cleaning.
Three-way distributor has a variety of names can be called electro-hydraulic three-way distributor valve, electro-hydraulic three-way chute, miter valve, electro-hydraulic three-way distributor has manual, electric, pneumatic, divided into positive three-way and side three-way.Model dsf-a (B) electro-hydraulic three-pass distributor can be used in the material commutation/diversion process.And allow reversing when the material flow is out of date;Df-c (D, E) type electro-hydraulic three-energy distributor can be used in the process of material commutation and diversion, and has the kinetic energy of the gate.Simultaneous control of material cutting or simultaneous circulation.
The three-pass distributor needs to pay attention to the wear of parts when it is used. If the wear is serious, it needs to be followed and replaced in time. Only in this way can the failure be avoided and the flexible performance in operation be enhanced.In order to let everyone's work efficiency can be improved, we should be in the maintenance of the transmission part of the lubricating oil addition, only in this way can reduce friction, natural work efficiency will improve a lot.Composite silicate board manufacturers told us in the use of the time must not appear overload, otherwise the damage to the machine is very serious.Clean up after operation to avoid corrosion.If we want to use the electro-hydraulic three-pass distributor, then we need to strengthen the daily maintenance, only in this way can the machine operate flexibly in use.In the operation of the machine to have a general understanding of the use method, only in this way will not be used in the operation of errors.