Pneumatic flip valveThe discharging mouth of the pneumatic flap valve body for slope, slope of discharging...
TD dry powder bucket elevatorTD dry powder bucket elevator structure:TD series bucket elevator features: simple str...
Single shaft dust humidifierUniaxial dust humidifier, uniaxial machinery, humidifying effect, the advantage is lar...
HMCN type long bag pulsed dust collectorHMCN type long bag pulsed dust collector is a new type of dust collector which is impr...
Vertical dust humidifierVertical dust humidifier is mainly used for all kinds of dry ash storage for wet mixin...Screw conveyor is used to transport powdery, granular materials transport equipment, all kinds of bearings are working in dust, so in such working conditions under the correct use of the screw conveyor is particularly important.So what is the correct way to use the screw conveyor?
The screw conveyor can only be started when there are no materials and sundries in the shell.
1. When the screw conveyor is running, it is necessary to pay attention to the magnitude of current fluctuation and solve the problem in time.The feeding should be stopped before the screw conveyor stops. The machine can stop until the materials in the shell are discharged.There should be no large and hard material in the input material, to avoid the damage of screw conveyor caused by screw jam.
2. The connecting parts of the screw conveyor shall not have the phenomenon of dust and air leakage, and shall keep its tightness.
3. When using the screw conveyor, it is necessary to check the working conditions of each part of the screw conveyor, pay attention to whether the fasteners loosen, and tighten the fasteners in time.
4. When the motor is started, observe the current and feed to the screw conveyor if normal.
5.in the feeding, should gradually increase the feeding speed has been up to the rated conveying capacity, feeding should be uniform, and keep the number of filling, try to avoid intermittent feeding, otherwise it is easy to cause the material transportation of the accumulation of plug, drive device overload, will reduce the service life of the conveyor.
6. In order to prevent metal debris from entering into the box of the screw conveyor, causing the bearing of the whole machine to get stuck and twisted, the feeding port of the screw conveyor should be added with screen.Before starting the machine, cover the box body of the screw conveyor well, and do not remove it when the machine is running, so as to ensure personal safety and prevent dust from flying.
